When you fish hard in the surf, it’s just a matter of time until you suffer a setback with your waders. Whether thru wear & tear or damaged by hazards.

If your waders has a manufacturer defect(s), such as defective stitching or leaky boot seam, they can be sent back to the manufacturer for repair or replacement. Most major brand name waders like Simms, Hodgman or brands carried by the Bass Pro Shops, have excellent warranty and they will work with you to get you back out in the water as quickly as possible.

If you damage your waders under normal use, it might faster and/or more economical to do the repair yourself.

I slipped on some mussels covered rock and damaged my waders a little while back.

Here are the steps that I took to repair them myself.


One of two nice size holes…



First, you will need to purchase a basic waders repair kit. These kits are relatively inexpensive and can be purchased at most fly fishing specialty shops, on-line or at some sporting goods store like Sports Authority. I purchased the kit below on Ebay for about $10.00.




Start with a pair of dry waders. You can also do repairs on the field (see extra steps towards the end of this post.)
Locate the damaged area(s).


Apply the temporary self-sticking patch to the damaged area. Make sure that the patch covers at least ˝ an inch around the entire hole or tear.
Here, I cut the patch in two pieces to cover both of the holes in my waders.




Turn the waders inside out and locate the damaged area from the “inside.”


Apply a generous coat of Aquaseal to the damaged area, making sure that the Aquaseal covers at least ˝ an inch around the affected area.




Allow to dry in room temperature for 8-12 hours.
When the Aquaseal is dry to the touch, turn the waders back to the outside and remove the temporary patch.
You are now ready to get back in action.


“Almost” as good as new…


If you damage your waders while out in the surf and don’t have a backup pair, but wish to continue fishing, you can follow these extra steps:
Apply the second patch to the “inside” of the waders on top of the Aquaseal and leave both patches in place. You can continue to fish and remove the patches later when the waders are completely dry.

Aquaseal is also good for reinforcing boots seam. The point where the boots are sewn on to your waders. Add a thin coat of Aquaseal along the seams to add extra protection against leaks.