PDA

View Full Version : Daiwa Steez 100HA Spool


basscatt
09-06-2012, 10:40 PM
I have a Daiwa Steez 100HA spool pulled from a reel I had e_bassfisher supertune and polish the internals. This spool is in amazing shape and comes with an Orange seal ABEC7 bearing installed. If you have a Daiwa Steez 103 it is made for throwing lighter baits.The 100 spool is made to hold more line and throw bigger baits than the 103 has a hard time throwing. This spool will fit in Daiwa Steez 103, Daiwa TDZ103H, TDX. I am asking 80.00 TYD for this fine piece of machinery, I will go by first post, email or PM. My email is trentgreer@att.net
http://i1181.photobucket.com/albums/x436/basscattrent/steez%20spool/steezspool005.jpg
http://i1181.photobucket.com/albums/x436/basscattrent/steez%20spool/steezspool004.jpg
http://i1181.photobucket.com/albums/x436/basscattrent/steez%20spool/steezspool003.jpg
http://i1181.photobucket.com/albums/x436/basscattrent/steez%20spool/steezspool002.jpg
http://i1181.photobucket.com/albums/x436/basscattrent/steez%20spool/steezspool001.jpg
basscatt
09-08-2012, 12:31 AM
How about 77.00 TYD for the Steez 100HA spool with ABEC7 Orange Seal Ceramic Bearing upgrade.
basscatt
09-08-2012, 07:51 AM
I was asked if this spool is a direct match to the TDZ reel. Here is an article on this subject, the bearing on the handle size are the same but you will have to replace the bearing on the palm side bearing with a 3x10x4. The TDZ has a 3x8x4 here is the article on this subject from Tackle Tour http://www.tackletour.com/articleinsidethedaiwasteez.html
basscatt
09-09-2012, 06:56 AM
Lets try 75.00 TYD for this awesome looking Steez 100HA Spool.
Nessie Hunter
09-09-2012, 11:03 AM
you will have to replace the bearing on the palm side bearing with a 3x10x4. The TDZ has a 3x8x4 here is the article on this subject from Tackle Tour http://www.tackletour.com/articleinsidethedaiwasteez.html

Devils advocate here, have to ask...
How do you get a 10mm wide bearing into an 8mm wide hole/bearing seat????
I Guess im from Missouri ~ you'll have to show me!!



.
basscatt
09-09-2012, 02:56 PM
Devils advocate here, have to ask...
How do you get a 10mm wide bearing into an 8mm wide hole/bearing seat????
I Guess im from Missouri ~ you'll have to show me!!



.

My bad sold